Trainer; To Enter The Trainer Mode - Spektrum DX7 User Manual

Trainer

The DX7 offers a programmable Trainer function that allows the transmitter to operate in three different
Trainer modes. Either the left or right rocker can be programmed as the trainer switch.
NORMAL:
The transmitter can be used as a master or slave but the slave transmitter must have the same programming (i.e.
reverse, travel adjust, dual rates, mixes, sub trims, etc.) as the master.
P-LINK:
In Pilot Link the master transmitter maintains control of all secondary functions (i.e. dual rate, expo, gear,
flaps, etc.) and only the primary stick controls (aileron, elevator, rudder and throttle) are transferred to the slave
transmitter when the trainer switch is pressed.
SLAVE/P-LINK:
In the Slave mode, the DX7 is used as a slave radio in conjunction with a Spektrum
master that is in P-LINK mode; there is no need to match the slave's programming to the master transmitter's
programming in this mode.
Press to enter
TRAINER FUNCTION
Hold while turning on the transmitter

To Enter the Trainer Mode

Press the DowN and SELECT keys simultaneously then turn on the transmitter.
Press the UP key until
Press the INCREASE or DECREASE key to select the desired Trainer type: INH, NORMAL,
SLAVE/P-LINK.
Also note that the trainer switch can be located on the right or left rocker switch. Use the SELECT key to
highlight SW:R

[TRAINER]
TRAINER function appears on screen.
then press the INCREASE or DECREASE key to select the
Press to select trainer type
≥NORMAL
SW:L-ROCKER
SPEKTRUM DX7 • AIRCRAFT PROgRAMMINg gUIDE
® radio that is used as the
P-LINK
RIgHT (R) or LEFT (L) rocker.
or