Input Select; To Access Input Select - Spektrum DX7 User Manual

Input Select

The purpose of the Input Selection Function is to assign the activation device for the AUX2 channel and
the Flap Channel.
Press to enter
INPUT SELECT
Hold while turning on the transmitter

To Access Input Select

Press the DowN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP key until the
Here you have 4 choices that can be used to operate the AUX2 channel:
• 2-position switch
• INH
• Rocker
• 3-position switch
(The rocker provides proportional control, while the switch allows 2 or 3 positions of the AUX2 channel. You can
also use the rocker for an AUX2 trim switch when using the 2P switch to activate the AUX2 function. Or you can
inhibit the AUX2 rocker as well to prevent inadvertent changes.)
In addition, you have 3 choices to activate/inhibit
• System (3-position switch)
• INH
• Rocker
(The rocker provides proportional control, while the system allows 3-position function of the FLAP channel. You
can also use the rocker for a FLAP trim switch when using the 3P switch to activate the FLAP function. Finally,
you can inhibit the FLAP Rocker as well to prevent inadvertent changes.)
Note: When operating the transmitter in a trainer mode (Normal or P-Link Master) the Trainer-
Flap Rocker is not available to control the flaps.
Note: The individual AUX2/spoiler operation is inhibited when AUX2/spoiler is coupled for
automatic landing attitude.

[INPUT SELECT]
≥AUX2: 2P SW
AUX2 TRIM:INH
FLAP: SYSTEM
FLAP TRIM:ACT
INPUT SELECT function appears on screen.
FLAP
INCREASE and DECREASE key
SYSTEM:
SPEKTRUM DX7 • AIRCRAFT PROgRAMMINg gUIDE