Elevator-to-Flap Mix Function
When the Elevator-to-Flap Mixing System is active, and a value of flaps is input, the flaps will be deflected each
time the elevator stick is used. The actual flap movement is independently adjustable for both up and down
elevator. A commonly used application is up elevator/down flaps and down elevator/up flaps. When used in this
manner, the aircraft pitches much more quickly than normal. The uppermost position of the Flap Mixing Switch
or the Mix Switch can be used to activate the Elevator-to-Flap Mixing function. When you want to reverse the
mixing directions, press the - key and change the mixing value from + to - (or - to +).
To Access the Elevator-to-Flap Mixing
In the Function Mode, use the UP or DowN key to select the
access by pressing the UP and DowN keys simultaneously.
Note: The flap mix switch, or the Mix switch, depending on which is selected, must be in the
"ON" position to adjust values.
To adjust the rate value, with the switch on, move the elevator stick in the desired position up or down and press
the INCREASE or DECREASE button to adjust the desired mix value.
To Select the Switch to Operate the Flap Mix
Press the SELECT key to highlight SW.
Press the INCREASE or DECREASE key to select the
SPEKTRUM DX7 • AIRCRAFT PROgRAMMINg gUIDE
Press to enter
ELEV-FLAP MIX
[ELEV->FLAP MIX]
Press to enter
Function Mode
Press to adjust value
◊RATE:≥D
0%
U
SW:FLAP0
Press to select
Rate or Switch
ELEVATOR TO FLAP MIXINg
MIX
or
FLAP0
ON
0%
switch position.
function and
1