Spektrum DX7 User Manual page 19

3. Establish the desired fail-safe stick positions: normally low throttle and flight controls neutral.
4. Press and hold the bind button on the back of the transmitter while turning on the power switch.
The bind button should flash and within a few seconds the system should connect. The LED's on the
receivers should go solid indicating the system has connected.
5. Remove the bind button and store it in a convenient place.
6. After you've programmed your model, it's important to rebind the system so the true low throttle and
neutral control surface positions are programmed.
Note: The AR7000 features DSM2
The AR7000 will not operate with the DX6 or Spektrum
SPEKTRUM DX7 • INTRODUCTION
POWER
™ technology and is only compatible with DSM2 transmitters.
® surface systems.
1