Set Ip Address; Address Setting - EverFocus EFC304 User Manual

NAV IP Access controller
The below screen will be shown in the DHCP setting submenu. Press
(DHCP enabled) and static IP (DHCP disabled). The default DHCP setting is disabled by default.
When DHCP is enabled, press
server and show the below screen, indicating the controller is getting IP address:
After the IP address has been obtained, controller shows the IP address in the below window:
At this window, press
5.10.2 Set IP Address
For a static IP setting, users need to manually set an IP address. Press
Network Setting to set IP address:
Input the desired IP address and press
When using static IP (DHCP disabled), NAV Controller will require the subnet mask and gateway setting
automatically after the IP address is set here.
Input the desired subnet mask and press
Input the desired gateway IP address and press
5.11 Address Setting
NAV Controller is connected to network for remote accessibility by IP Address, but it must have a unique
address for the purpose of communications and control by the Management Software when there is
more than one controller.
Press six times from main menu items to view the below screen:
DHCP Setting
DHCP Enabled
[ENT] to toggle
to exit and NAV Controller will update the IP address from DHCP
Getting IP...
IP Address:
192:168:000:106
to update the IP address again. Press
IP Address:
___:___:___:___
to confirm. The default IP address is 192.168.1.200
Subnet Mask:
___:___:___:___
to confirm.
Gateway:
___:___:___:___
57
key to toggle between DHCP
to exit to "DHCP Setting" window.
under the below submenu of
to confirm.