Set Time; Auto Daylight Saving Time; Set System Pin - EverFocus EFC304 User Manual

5.5.4 Set Time
Press at the below window to set the time.
The LCD will display the following menu. Use the numerical keys to input the current time as a six‐digit
number (HH: MM: SS). The time must be in the range 00:00:00‐‐23:59:59. After entering the time, press
to confirm.
5.5.5 Auto Daylight Saving Time
Press at the below window to adjust the settings for Auto Daylight Savings:
Press to toggle the setting between Enabled/Disabled, Press
When auto daylight savings is turned on, set the auto daylight start/end time from the built‐in
management software remotely.
5.5.6 Set System PIN
A System PIN must be entered before the user can make management changes via the controller keypad.
The factory default System PIN is 00000000. It is recommended that the password is changed after the
initial log‐in for maximum security. Be sure to secure the new password; if lost, the system can only be
accessed after purging all stored data using the reset button on the main board.
Press at the below window to set system PIN.
The LCD will display the following menu.
Enter a new system PIN. Enter it a second time to confirm. Press
Pressing at any time will exit the menu without changing the system PIN.
Set Time
Set Time
__:__:__
Auto Daylight
Saving
DaylightSaving:
Yes [ENT] to toggle
Set SYS Password
Input SYS Password
________
to exit
DaylightSaving:
No [ENT] to toggle
32
NAV IP Access controller
to set the new system PIN.