Table of Contents
Advertisement
NAV IP Access controller
Press
to enter Over Time setting. Use
Input the desired door hold open time in the Open Time field: enter minutes as a 3‐digit number 0~999,
and enter seconds as a 2‐digit number 0~59. Press
any change.
5.8 Reader Setting
Card reader properties can be directly set on the controller, including whether the reader is keypad
reader, the allocation of readers to doors, and system reader etc.
5.8.1 Enter Reader Setting Menu
Under System menu, press
Press
to enter Reader Setting menu. Use
All menu options under Reader Setting are introduced below:
5.8.2 System Reader Setting
System reader can be used to acquire the card's serial number when controller configures the card. User
can set any reader that connects to the controller as the system reader. At the following submenu:
Press
to enter System Reader setting. System will show current status of all readers as shown
below. Y means the reader is the system reader, N means it's not. By default, no reader is set as the
system reader. Users have to set it manually.
Press any of the 1‐8 numeric keys to change the system reader setting of corresponding readers. Press
to exit.
5.8.3 Keypad Setting
Keypad Setting defines whether the reader is a keypad reader. For a keypad reader, if the PIN property
of the card is set as enabled, and the access rights of the door are set as card plus PIN, then the user is
asked to enter password when the card is swiped on the keypad reader. At the following submenu:
Press
to enter keypad setting. System will show keypad setting status of all installed readers. Y
means the reader is a keypad reader, and N means the reader is a non‐keypad reader. By default, every
Door-1Over Time
000Min 05 Sec
to confirm. Press
twice to bring up the following window:
Reader Setting
and
System Reader
Setting
12345678
NNNNNNNN
Keypad Setting
43
and
to choose from different door.
to exit without effecting
to choose from different menu options.
Advertisement
Table of Contents
