NAV IP Access controller
2. Installation
The Installation has three procedures described as below. Each procedure will be
introduced in the following sections in detail.
Step 1: Installation Preparation
Obtain a floor plan
Determine the hardware and location
Determine the number of controllers according to
system structure
Step 3: Software Setup / Configuration
Log in controller built‐in software through IE on computer
Set user account for user software
Set controller and other equipment
Set holidays, shifts and door control rules
Log in card and set card attributes
2.1 Installation Preparation
Before installation, users are advised to collect information properly which will make the
installation more smoothly and helps to reduce time and energy cost. For professional
constructors, the information below will be of great use.
2.1.1 Obtain a Floor Plan
Obtain a floor plan of the building in which the access control system is to be installed.
Step 2: Hardware Installation
Installing the controller
Connecting to the door lock / open button / sensor / bell
Connecting to the alarm input / output
Connecting to the card reader
Connecting to the computer through the networkMount a
backup battery in the enclosure
11
Chapter
2