Table of Contents
Advertisement
Press
to prompt to input new PIN, press
If repeat PIN is different from first time input, it will prompt,
After modify, it will prompt,
5.6.5 Show Card Number
This function can be used to show the serial number of a card when it is swiped on the system reader.
Under Card Setting menu, press
Press
and swipe the card on the system reader. The serial number of the card will be displayed as
shown below. Press
5.7 Door Setting
Every door module controls two door relays. NAV Controller can control up to 8 doors in total, defined
as door 1 to 8 from right to left. According to reader setting above, users can allocate multiple readers to
one single door. User can directly set door unlock time, door held open time and the door control at fire
alarm on the controller.
5.7.1 Enter Door Setting Menu
Under System menu, press
Press
to enter Door Setting menu. Use
menu options under Door Setting are introduced below.
5.7.2 Schedule Switch Setting
Door verification indicates the access mode when a cardholder enrolls the card on the reader in order to
enter/exit the door, for example, a dual security method could require both card and PIN, or both card
and fingerprint.
Input new PIN:
________
Password mismatch,
please retry
Password updated
successfully
three times to bring up the following window:
Show Card Number
to exit.
Registed:
Card#:000006703392
three times to bring up the following window:
Door Setting
to repeat new PIN.
Repeat:
________
No
and
to choose from different menu options. All
40
NAV IP Access controller
Advertisement
Table of Contents
