Erase All Events; Load Factory Default; Card Setting; Enter Card Setting Menu - EverFocus EFC304 User Manual

NAV IP Access controller
5.5.11 Erase All Events
The controller will record all events that occur, beginning immediately upon powering on. These events
can be purged by following the instructions below. The old records will be automatically overwritten
when storage space is full (1,000,000 events max.).
Press at the window below to erase all events.
LCD will prompt the user to confirm the action:
Pressing will result in all events being permanently erased.
Caution
: this operation will permanently delete ALL events from the controller database. This
operation is NOT undoable.
5.5.12 Load Factory Default
This function is used to reset all settings to factory set default values.
Press at the window below to reset all settings.
The LCD will prompt the user to confirm the action. Press
Caution
: this operation will recover all the settings to the factory default. This operation is NOT
undoable.
5.6 Card Setting
Card setting can be configured using either the controller or the built‐in management software. Using
the built‐in management software is the easiest way to enroll cards. However, enrolling at the controller
can be useful if the controller is offline. The process is described below.
5.6.1 Enter Card Setting Menu
Under the System Menu, press
Erase All Events
Are you sure?
[ENT] to continue
Restore Factory
Settings
once to bring up the following window:
35
to confirm and perform the reset action.