NAV IP Access controller
NAV Controller supports a comprehensive door verification schedule on each door. The door verification
can be defined individually on a schedule with 10 types of date, 6 time zones on each type of date. If the
user just wants to have a consistent access mode all the time every day, schedule switch can be set as
OFF to have only one door verification mode, defined in the next section.
At the following submenu, press
Press
to toggle between enable/disable door verification schedules. Press
5.7.3 Door Access Mode
As described in previous section, NAV Controller will use the controller door access mode if the schedule
switch is turned off. NAV Controller supports 13 types of door access modes, for example: always open,
card only, fingerprint only and so on.
At the following submenu, press
Before setting the door verification mode, users first have to select the door to be set, refer to the below
window:
After the door number is entered, press
modes followed with a star "*" mark is the currently selected mode. All the door verification modes are
listed below:
to enter to the setting for door verification schedule:
ScheduleSwitch
Setting
Schedule Enabled
[ENT] to toggle
to set the controller door access mode:
Door Access Mode
InputDoor
Index: _
to toggle among all available door verification modes. The
Card Only
*Yes
Fingerprint Only
Card + PIN
Card + Fingerprint
Fingerprint + PIN
Card + PIN +
Fingerprint
Card or PIN or
Fingerprint
Schedule Disabled
[ENT] to toggle
41
to exit.