5.6.4.1
Firmware update
Plug the USB drive that contains the firmware file into the USB port of the controller. Press
below screen of system maintenance menu to start the firmware updating process.
The controller will show the below screen if no valid firmware is found from the plugged USB drive.
5.6.4.2
Database restore
Plug the USB drive that has the previous backup database file into the USB port of the controller. Press
at the below screen to start database storing process.
If no valid database data available, the controller shows the below information:
5.6.4.3
Database backup
Plug the USB drive into the USB port of the controller. Press
database to the USB drive:
If no USB drive presented when the menu item is selected.
5.6.4.4
Unmount USB storage
USB drive can be hot swapped, but sometime the data will be loss caused by pulling out directly. It is
safer that removed from the controller. Press
when finishing backup and restoring the database from the backup file on USB drive:
If no USB drive presented when the menu item is selected.
System
Maintanence
Update system
No system update file
find
Restore database
No valid backup
filefind
Backup database
No usbstorage found
under the below screen to unmount the USB drive
Umount usb storage
No usbstorage found
34
NAV IP Access controller
under the below screen to backup the
at the