Front Park/Turn Signal; Front Side Marker; Front Fog Lamp - Jeep Wrangler 2013 Owner's Manual

Hide thumbs Also See for Wrangler 2013:

Table of Contents

616 MAINTAINING YOUR VEHICLE

Front Park/Turn Signal

1. Remove the front grille. Turn the retainers along the

top 1/4 turn counterclockwise and remove.

2. Pull the bottom of the grille away starting at one side

and working toward the other.

3. Turn the socket assembly 1/4 turn counterclockwise

and remove from housing. Pull the bulb straight from

the socket to replace.

1. Reach under the front fender flare and locate the front

side marker socket.

2. Turn the socket assembly counterclockwise 1/3 turn

and remove it from the housing. Pull the bulb straight

from the socket to replace.

1. Reach under the vehicle to access the back of the front

2. Disconnect the wire harness connector from the front

fog lamp connector receptacle.

3. Firmly grasp the bulb by the two latch features and

squeeze them together to unlock the bulb from the

back of the front fog lamp housing.

4. Pull the bulb straight out from the keyed opening in

the housing and then connect the replacement bulb.

Do not touch the new bulb with your fingers. Oil

contamination will severely shorten bulb life. If the

bulb comes in contact with any oily surface, clean the

bulb with rubbing alcohol.

Table of Contents