Esc Activation/Malfunction Indicator Light And Esc Off Indicator Light - Jeep Wrangler 2013 Owner's Manual

472 STARTING AND OPERATING
Partial Off
When in "Partial Off" mode, the TCS portion of ESC has
been disabled and the "ESC Activation/Malfunction
Indicator Light" will be illuminated.
All other stability features of ESC function normally. This
mode is intended to be used if the vehicle is in deep
snow, sand, or gravel conditions and more wheel spin
than ESC would normally allow is required to gain
traction. To turn ESC on again, momentarily press the
ESC OFF switch. This will restore the normal "ESC On"
mode of operation.
NOTE: To improve the vehicle's traction when driving with
snow chains, or starting off in deep snow, sand, or gravel, it
may be desirable to switch to the "Partial Off" mode by
pressing the ESC OFF switch. Once the situation requiring
ESC to be switched to the "Partial Off" mode is overcome,
turn ESC back on by momentarily pressing the ESC OFF
switch. This may be done while the vehicle is in motion.
ESC Activation/Malfunction Indicator Light And
ESC OFF Indicator Light
The "ESC Activation/Malfunction Indicator
Light" in the instrument cluster will come on
when the ignition switch is cycled to the ON
position. It should go out with the engine
running. If the "ESC Activation/Malfunction Indicator
Light" comes on continuously with the engine running, a
malfunction has been detected in the ESC system. If this
light remains on after several ignition cycles, and the
vehicle has been driven several miles (kilometers) at
speeds greater than 30 mph (48 km/h), see your autho-
rized dealer as soon as possible to have the problem
diagnosed and corrected.
The "ESC Activation/Malfunction Indicator Light" (lo-
cated in the instrument cluster) starts to flash as soon as
the tires lose traction and the ESC system becomes active.
The "ESC Activation/Malfunction Indicator Light" also
flashes when TCS is active. If the "ESC Activation/