High/Low Beam Switch; Flash-To-Pass; Front Fog Lights; Instrument Panel Dimmer - Jeep Wrangler 2013 Owner's Manual

Hide thumbs Also See for Wrangler 2013:

Table of Contents

172 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

High/Low Beam Switch

Push the multifunction lever away from you to switch

the headlights to high beam. Pull the lever toward you, to

switch the headlights back to low beam.

You can signal another vehicle with your headlights by

lightly pulling the multifunction lever toward you. This

will turn on the high beams headlights until the lever is

The front fog light switch is located on the multi-

function lever. To activate the front fog lights, turn

on the parking or low beam headlights and pull out the

end of the lever.

NOTE: The fog lights will only operate with the parking

lights or the headlights on low beam. Selecting high

beam headlights will turn off the fog lights.

Rotate the center portion of the lever to the extreme

bottom position to fully dim the instrument panel lights

and prevent the interior lights from illuminating when a

door is opened.

Rotate the center portion of the lever up to increase the

brightness of the instrument panel lights when the park-

ing lights or headlights are on.

Rotate the center portion of the lever upward to the next

detent position to brighten the odometer and radio when

the parking lights or headlights are on.

Table of Contents