Jeep Wrangler 2013 Owner's Manual page 513

message is then followed by a graphic display, with
pressure values still shown. This indicates the pressure
values are still being received from the TPM Sensors but
they may not be located in the correct vehicle position.
However, the system still needs to be serviced as long as
the SERVICE TPM SYSTEM message exists.
NOTE:
• If your vehicle is equipped with a matching full-size
spare wheel and tire assembly, it has a tire pressure
monitoring sensor, and can be monitored by the Tire
Pressure Monitoring System (TPMS). In the event that
the matching full-size spare tire is swapped with a low
pressure road tire, the next ignition switch cycle will still
show the "Tire Pressure Monitoring Telltale Light" to be
ON, a chime to sound, a "LOW TIRE PRESSURE"
message to appear in the EVIC, and the graphic display
will still show the low tire pressure value "flashing."
Driving the vehicle for up to 20 minutes above 15 mph
(24 km/h) will turn OFF the "Tire Pressure Monitoring
Telltale Light" as long as none of road tires are below the
low pressure warning threshold.
• If your vehicle is not equipped with a matching
full-size spare wheel and tire assembly, it does not
have a tire pressure monitoring sensor in the spare tire.
The TPMS will not be able to monitor the tire pressure.
If you install the spare tire in place of a road tire that
has a pressure below the low-pressure warning limit,
upon the next ignition switch cycle, the "Tire Pressure
Monitoring Telltale Light" will remain ON, a chime
will sound, and the EVIC will still display a "flashing"
pressure value in the graphic display. After driving the
vehicle for up to 20 minutes above 15 mph (24 km/h),
the "Tire Pressure Monitoring Telltale Light" will flash
on and off for 75 seconds and then remain on solid. In
addition, the EVIC will display a "SERVICE TPM
SYSTEM message for a minimum of five seconds and
then display dashes (- -) in place of the pressure value.
STARTING AND OPERATING 511
5