General Information - Jeep Wrangler 2013 Owner's Manual

Hide thumbs Also See for Wrangler 2013:

Table of Contents

512 STARTING AND OPERATING

For each subsequent ignition switch cycle, a chime will

sound, the "Tire Pressure Monitoring Telltale Light"

will flash on and off for 75 seconds and then remain on

solid, and the EVIC will display a SERVICE TPM

SYSTEM message for a minimum of five seconds and

then display dashes (- -) in place of the pressure value.

Once you repair or replace the original road tire, and

reinstall it on the vehicle in place of the spare tire, the

TPMS will update automatically.

In addition, the "Tire Pressure Monitoring Telltale Light"

will turn OFF and the graphic in the EVIC will display a

new pressure value instead of dashes (- -), as long as no

tire pressure is below the low-pressure warning limit in

any of the four active road tires. The vehicle may need to

be driven for up to 20 minutes above 15 mph (24 km/h)

in order for the TPMS to receive this information.

General Information

This device complies with part 15 of the FCC rules and

RSS 210 of Industry Canada. Operation is subject to the

following conditions:

• This device may not cause harmful interference.

• This device must accept any interference received,

including interference that may cause undesired

The tire pressure sensors are covered under one of the

following licenses:

United States

2546A-C4W4MA4

Table of Contents