Key Indicator Lights; Stand-By Switching - Barco Coronis 5MP User Manual

Key indicator lights

By default, the indicator lights of the keys,
dimmed which makes the keys unavailable at that moment.
To make the keys illuminate and available for further actions touch one
of the keys. As a result, all keys will be illuminated and are now
available for further actions. However, if no further actions are taken
within the following 5 seconds, the keys will dim again.
The key auto-dim function can be disabled in the OSD menus.
Please refer to "To configure the key indicator lights:" on
page 35 for detailed instructions on how to do this.

Stand-by switching

The connected power supply also provides a switch that can be
used to turn the power completely off. To use the display,
please make sure to switch on this power supply. This can be
done by pushing the on/off switch on the power supply into
the "|" position.
Switching on the display while it is in stand-by mode or vice versa can
both be done by:
Illuminate the keys as previously described.
1
While the keys are illuminated, touch the
2
approximately 2 seconds.
, , and will be
key for
Coronis 5MP
29