Parallel Interface Mode - SATO GL4xxe Series Operator's Manual

MENU
Poll Response
0 ms*
Idle Response
Disable*
One Char Enquiry
Disable*
Printer Status
Disable*
Framing Errors
Enable*
MENU
INTERFACES
INTERFACES
Ignore CR/LF
Item No. Check
BCC Check
History Buffer
Comm. Protocol
Host Interface
Parallel Port
USB Port
Serial Port
Printer Mgmt
GL408-412e Operator's Manual
Unit 4: Printer Configuration
SERIAL INTERFACE MODE (TABLE 4-4)
This option is for the Series1 protocol. After receiving a poll character, the printer will wait the poll
response time in milliseconds before sending the response.
The allowable range is 0 to 30 ms, and the factory default is 0 ms.
This option is for the Series1 protocol.
• Disable - factory default.
• Enable - the printer sends a response character every two seconds while the quanity of valid
bytes in the buffer is less than 75 percent of the buffer size.
One Character Enquiry. This mode uses the poll character to detect a request from the host and
sends a response back to the host.
• Disable - factory default. Poll character will not detect.
• Enable - poll character will detect.
If enabled, allows the printer to respond according to two different response tables when an ENQ
command is sent to the printer.
• Disable - factory default. A response is not sent.
• ENQ/STX - when the printer receives an ENQ, the printer responds with a status according
to ENQ/STX parameters.
• ENQ - when the printer receives an ENQ, the printer responds with a status according to
ENQ parameters.
These are possible errors that can occur when serial interface settings of the printer do not match
those of the host computer.
• Enable - factory default. If a framing error occurs, a fault message will display on the
operator panel.
• Disable - if a framing error occurs, a fault message will not display on the operator panel.
PARALLEL INTERFACE MODE (TABLE 4-5)
Permits entry into the INTERFACES Mode.
Is the menu selection screen for the INTERFACES Mode.
DESCRIPTION
DESCRIPTION
4-44