SATO GL4xxe Series Operator's Manual page 129

ERROR SIGNALS
DISPLAY
DOWNLOADER ERROR
FLASH WRITE #4
Repeat Download
DOWNLOADER ERROR
FLASH W ADDR BAD
Repeat Download
DOWNLOADER ERROR
MAIN FLASH IS FULL
Optimize Files
DOWNLOADER ERROR
NO EFC DETECTED
Repeat Download
EC SOFTWARE FAIL
Cycle Power
ERROR: INSUFFICIENT
DRAM
Cycle Power
ERROR: INSUFFICIENT
FLASH
Cycle Power
ERROR: WRONG
CHECKSUM
Repeat Download
GL408-412e Operator's Manual
Unit 5: Troubleshooting
EXPLANATION
A Flash Write failed to complete.
An attempt was made to write to flash where it
wasn't present.
An attempt was made to download to a full main
flash memory.
The printer's firmware attempted to access an
EFC that wasn't present.
Engine control software failure.
Not enough RAM memory available for the
printer to function.
The printer requires more flash memory to
download program.
The printer received the complete program but
the checksum did not match. The data may have
been corrupted during download.
Try downloading again or contact an authorized
customer service representative.
Try downloading again or contact an authorized
customer service representative.
Delete and optimize files.
Contact
representative.
Power off the printer for 15 seconds, then power
on again. If the problem persists, contact an
authorized customer service representative.
Power of the printer for 15 seconds, then power
on again.
If the message reappears, increase the Glob
Mem Adjust size in the PRINTER SETUP menu
and reboot the printer.
If the message reappears, replace the main
circuit board. Write down the message and
return it with the defective board.
Power off the printer for 15 seconds, then power
on again. If the problem persists, contact an
authorized customer service representative.
Power off the printer for 15 seconds, then power
on again. If the problem persists, contact an
authorized customer service representative.
5-4
SOLUTION
an authorized customer service