Diagnostics Mode - SATO GL4xxe Series Operator's Manual

MENU
IGL Setup
Save state*
MENU
DIAGNOSTICS
DIAGNOSTICS
Priority Setting
Printer Tests
Test Count
Software Build
Hex Dump Mode
Print Error Log
Clear Error Log
Flash Installed
DRAM Installed
Ptr On Time
Printer Usage
PrintHead Usage
Head On Time
Reset Head Data
PrintHead Usage
Head Type
Head Voltage
Priority Setting
Command*
GL408-412e Operator's Manual
Unit 4: Printer Configuration
IGL EMULATION MODE (TABLE 4-14)
This menu saves the current state of the printer to flash memory. The pages, formats, and fields
that currently exist in RAM memory save to flash memory and are restored at power up. This
allows the format to be sent once and make it resident in the printer.
Note: Saving the state does not save general printer settings for which configuration menus are
provided. These settings are saved by storing the configuration, and selecting that configuration
as the power up configuration. Examples of settings that can be configured this way by host
control are print speed, print density, and media handling (continuous, tear-off, etc.).
DIAGNOSTICS MODE (TABLE 4-15)
Permits entry into the DIAGNOSTICS Mode.
Is the menu selection screen for the DIAGNOSTICS Mode.
Allows the selection of which type of programming will take priority precedence in determining
Print Darkness, Print Speed, and Print Offset.
• Command - factory default. Any commands in the label job will take precedence and be
used for printing. The LCD will reflect the new setting.
• LCD - Any settings established through the printer's operator panel will be used for an
incoming print job regardless of different command settings.
DESCRIPTION
DESCRIPTION
4-82