SATO GL4xxe Series Operator's Manual page 73

MENU
Extra Bold Char.
504*
OCR-A Chars.
384*
OCR-B Chars.
304*
Tall Characters
Disable*
Batch Counter
Disable*
ADVANCED MODE
Disp. Intensity
Disp. Intensity
8*
SENSOR SETUP
Sensed Distance
Sensed Distance
XX.X mm
GL408-412e Operator's Manual
Unit 4: Printer Configuration
ADVANCED MODE (TABLE 4-3)
This menu entry permits the thickness or font weight of extra bold text fonts to be adjusted. The
range is 0 to 512, and the factory default is 504.
For most applications, the default settings for font memory is acceptable. Therefore, do not
change the defaults unless the application requires an uncommon memory configuration.
Permits character weight adjustment of resident OCR-A characters. The allowed range is 0 to
512, and the factory default is 384.
Permits character weight adjustment of resident OCR-A characters. The allowed range is 0 to
512, and the factory default is 304.
Increases the point height of resident Intellifont characters.
• Disable - factory default. Standard resident font character height is maintained.
• Enable - increases the point height by approximately 10%.
Permits the display of the quantity of pages remaining in a print job.
• Enable - factory default. Will display on the operator panel LCD. Is only supported in PGL
and ZGL. If the correct execute command is absent from the print file, "0 Pages" will
continually display.
• Disable - the quantity of pages remaining to be printed will not display. Instead, the Active
emulation and interface will display on the operator panel LCD.
Display Intensity. Is a menu option within the main menu of the ADVANCED MODE and allows
advancement to the Disp. Intensity sub-menu.
Display Intensity. Allows the light intensity of the operator panel LCD to be adjusted. The
allowable range is 0 to 20, the factory default is 10.
Is the first menu screen of the Sensor Setup portion of the ADVANCED MODE. The sub-menus
to follow allow values and settings to be established relative to the printers media sensors.
This value represents in inches, the distance that was sensed between the top-of-form of one
label to the top-of-form of the next label. With gapped media loaded, the distance equals the
physical label length plus one gap, notch, or hole (trailing edge to trailing edge).
With eye-mark media loaded, the distance equals the leading edge of one eye-mark to the
leading edge of the next eye-mark. This value is automatically determined only after successful
completion of Auto or Manual Calibrate and cannot be manually changed. The factory default is
0.00 inches.
DESCRIPTION
4-36