SATO GL4xxe Series Operator's Manual page 118

MENU
TOF set Cmd (F)
Process*
LRP adj. Cmd (f)
Process*
Speed Cmd (S)
Process*
Stock Cmd (T)
Process*
Vert. DPI Adjust
0*
Reported model
Auto detect*
Saving UDCs
Automatic*
GL408-412e Operator's Manual
Unit 4: Printer Configuration
IGL EMULATION MODE (TABLE 4-14)
Top-Of-Form Set Command. This menu defines if the <ESC>SIF command which sets the start
print point, is acknowledged.
• Process - factory default. Acknowledges the commands.
• Ignore - does not acknowledge the commands.
Label Rest Point Adjust Command. This menu defines if the <ESC>SIf command is
acknowledged.
• Process - factory default. Acknowledges the commands.
• Ignore - does not acknowledge the commands.
This menu defines if the <ESC>SIS command which set print speed is acknowledged.
• Process - factory default. Acknowledges the commands.
• Ignore - does not acknowledge the commands.
Note: If the print/feed speed is adjusted using the operator panel, host commands will not
override operator panel settings.
Stock Command. This menu defines if the <ESC>SIT command which sets media handling is
acknowledged.
• Process - factory default. Acknowledges the commands.
• Ignore - does not acknowledge the commands.
Vertical Dots-Per-Inch Adjustment. This menu fine adjusts the resolution used to convert the
coordinates of page elements (barcodes, font fields, graphic images, lines, boxes). The
coordinates received from the host are converted to engine resolution (203 or 300 dpi).
In cases where the printed label length is incorrect, the vertical resolution value IGL uses for
calculations can be fine adjusted.
Negative values result in a lower DPI value and thusly, a longer label. Positive values result in a
higher DPI value and thusly, a shorter label.
The allowable range is -100 to +100 with a factory default of 0.
Note: This adjustment does not affect the size of fonts and barcodes.
This menu defines which printer model IGL reports on the <ESC>M command. Manual selection
may be needed in cases where the auto-detected Intermec model does not support a feature
wanted. For example, TrueType font download is not supported on an Intermec 3600 printer. IGL
always supports this feature. To download TrueType fonts via the Intermec utility, the user can
set the model to 4420E which does support this download. This setting only affects the model
reported to the host - it will not affect the IGL in any other way.
• Auto Detect - factory default. Will report a model that cooresponds with the actual width and
resolution of the printer running IGL.
• 3600 - printer model.
• 4420E - printer model.
• 4630 - printer model.
• 4830 - printer model.
Saving User-Defined-Characters. This menu defines if UDC's are automatically saved to flash or
manually via the Save State menu.
• Automatic - factory default. The file system can run full because it is not automatically
optimized.
• Use Save State - used in cases where UDC's are sent repeated for each label.
DESCRIPTION
4-81