SATO GL4xxe Series Operator's Manual page 60

MENU
Ver Print Offset
00.0 mm*
Hor Print Offset
00.0 mm*
Label Length
152 mm*
Label Width
104 mm*
Slash Zero
Disable*
Character Pitch
Proportional*
Protocol C. Code
Standard*
Euro Character
213*
GL408-412e Operator's Manual
Unit 4: Printer Configuration
USER MODE (TABLE 4-1)
Specifies the distance to advance or retract the print image on the label to determine its vertical
positioning. The actual image height is not affected by this adjustment, only its location.
The factory default is -1.00 inches with a range of 6.00 inches. A negative value (-) retracts the
image and a positive value (+) advances the image placement on the label.
Specifies the lateral distance to move the print image on the label to determine its horizontal
positioning. The actual image width is not affected by this adjustment, only its location.
The factory default is 0.00 inches with a range from -1.00 inch to +1.00 inch. A negative value (-)
moves the image closer to the printer's center frame and a positive value (+) moves the image
from the printer's center frame.
Typically specifies the physical label length of the media installed. However, the type of media in
addition to its size it a determinant.
• Die-Cut Labels - the measurable length of the removable label. Does not include the liner
material or gap.
• Tag Stock w/ notices or holes - the measurable length is from the trailing edge of one notch
or hole to the leading edge of the next notch or hole.
• Tag Stock w/ black marks on underside - the measuarable length from the leading edge of
one black mark to the leading edge of the next black mark.
• Continuous Media w/o indicators - the measurable length depends upon the image size.
The allowable label length is from 0.1 to 0.99 inches (2.5 - 2514.6mm). The factory default is 6
inches. The label length allowable is dependent on the label's width and the printhead resolution
in use.
Specifies the physical width of the print image. The allowable range is 0.1 to 4.1 inches (2.5 -
104mm).
Deternimes if a zero is printed with or without a diagonal slash through it.
This setting determines whether each printer character occupies a designated space (Fixed)
regardless of the character's width, or if the character's space is representative of its width
(Proportional).
Proportional is contemporarily perferred.
The ESC sequence in SBPL commands may be defined as standard (using non-printable code
1BH) or non-standard (Hex 5E).
Changes the address of the Euro character.
DESCRIPTION
4-23