SATO GL4xxe Series Operator's Manual page 116

MENU
Select
IGL*
IGL Setup
Active
Error Reporting
Mode on Power Up
Print Language
IBM Translation
Slash Zero
EURO-Symbol
Preparsing Data
Status on <ETX>
Cutter Cmd (c)
PwrUpMod Cmd (C)
EOP Dist Cmd (D)
Intens. Cmd (d)
TOF set Cmd (F)
LRP adj. Cmd (f)
Speed Cmd (S)
Stock Cmd (T)
Vert. DPI Adjust
Reported model
Saving UDCs
Save state
IGL Setup
Active*
Active
Yes*
Error Reporting
Display on LCD*
Mode on Power Up
Advanced 5mil*
Print Language
US ASCII*
GL408-412e Operator's Manual
Unit 4: Printer Configuration
IGL EMULATION MODE (TABLE 4-14)
Allows the selection of the specific emulation to be selected from a list.
The allowable emulation options are: PGL for Printronics, ZGL for Zebra, TGL for TEC, IGL for
Intermec, SGPL for SATO, and DGL for Datamax.
Is the menu selection screen for the EMULATION Mode.
Allows transition to the Active menu screen.
Allows for non-IGL formatted text to either be printed or ignored.
• Yes - factory default. All data is parsed by the PPI/IGL emulation. Non-PPI/IGL data is
absorbed.
• No - all data is is passed to the LP+ emulation.
Determines where and how errors in the data stream will be displayed.
• Display on LCD - factory default. Error will display on the printer's LCD. Upon detection, the
printer will beep once. Each error will display for a half second, then the printer will go offline
and will print the data as best possible.
• Disable - errors are printed as best possible, but not displayed on the printer's LCD.
Allows the selection of the printer's print resolution.
• Advanced 5mil - factory default. Standard for 203 dpi.
• Emulation 10mil - for 100 dpi.
• Emulation 15mil - for 67 dpi.
Note: This menu does not appear when a 300 dpi print head is installed. When a 300 dpi print
head is installed, the mode will always be Advanced 3.3mil.
This menu selects the printed character language.
The factory default is US ASCII.
DESCRIPTION
4-79