Starting A Transaction; Sale Transactions - Ingenico iCT220 User Manual

6.

Starting a Transaction

IMPORTANT INFORMATION
Your terminal may be configured to start a transaction by either entering the transaction amount first or
by inserting/swiping the payment card.
If your terminal is configured to accept Contactless payments it will always expect you to enter the
transaction amount first for whichever type of transaction you are performing.
If your terminal is configured to request the card details first the customer will be required to insert
their card into the PINpad' rather than the terminal. Once this is done, enter the transaction amount
and continue from the 'Checking Card' prompt for the chosen transaction type.
PLEASE NOTE: In this guide the PINpad displays are shown alongside the terminal displays so that you
know what the customer is being asked to do.
1. At the READY PROMPT you may be asked to "Key in the amount" of the sale or to "insert or swipe"
customer card.
Terminal Displays
SALE
Present, Insert, Swipe
Card to Continue
(or press Cancel key)
If you make a mistake, press the YELLOW button and re-enter the correct amount.
If the card is a Chip card, please see Sale (Inserting a Card) in Section 7.
If the customers card is a Contactless card and is to be used for a Contactless transaction,please see
Sale (Contactless) in Section 7.
If the customers card has been swiped, please see Sale (Card Swiped) in Section 7.
7.

Sale Transactions

Sale (Inserting a Card)
1. Customer will be prompted to insert card into the PINpad.
SALE
Insert, Swipe Card
to Continue
(or press Cancel key)
2. The terminal will check the card. If the customer presents a card which supports multiple card
schemes you may be required to chose which card scheme to use.(See Section 5, Application
Selection.
SALE
Checking Card
Please Wait...
£10:00
PINpad Displays
AMOUNT
PRESENT OR INSERT
CARD
INSERT CARD
OR
HAND CARD TO
OPERATOR
PROCESSING
PLEASE WAIT
DO NOT REMOVE
CARD
£9.50
Page 13