Ingenico iCT220 User Manual page 8

PLEASE NOTE: If you have Call Waiting and select NO when prompted, the terminal will be unable to
dial for authorisation when a call message is waiting.
3. Key in your Merchant Number and press the GREEN button.
Terminal Installation
Key in Merchant No.
and then press ENTER
The terminal will start to dial Ingenico terminal configuration system (GEMS) and a number of
communication messages will be displayed.
Terminal Installation
Connecting to
<Acquirer Name>
Please Wait...
Once the configuration call completes, the terminal will then contact each acquirer of the cards it is
configured to accept. Further communications messages will be displayed.
Hardware Serial
Validation
Required
Press ENTER
An installation report will then be printed displaying the card types that your terminal will accept.
NOTE: If the print out shows cards type not accepted please contact the Helpdesk.
The PINpad will now be installed; when you see the display below press the GREEN button.
The terminal will start to dial the GEMS to validate the PINpad serial number.
Once the call to GEMS has completed the installation of the PINpad is complete.
Installation of the terminal and the PINpad is now complete and the terminal will display the READY
prompt. The terminal and PINpad are now ready for use.
READY
Merchant Number
12345678
Before you start using the terminal confirm that the date and time are correct. If this needs to be
amended refer to Section 28 of this guide for details.
<Software Version>
<Serial Number>
Ready
<Software Version>
<Serial Number>
Ready
POWERING UP
Please Wait...
<IDLE DISPLAY>
Page 7