Table of Contents
Advertisement
4.6.2 RJ45 Twisted-Pair Data Ports
The M2100 series switches may have several 10/100BaseTX ports that allow connection to
standard CAT-5 UTP cable with RJ45 male connectors. The RJ45 receptacles are directly
connected to the chassis ground and can accept shielded CAT-5 cables. If shielded cables are
used, care must be taken to ensure the shielded cables do not form a ground loop via the shield
wire and the RJ45 receptacles at either end.
Pin
Signal
1
RX+
2
RX-
3
TX+
4
No Connection
5
No Connection
6
TX-
7
No Connection
8
No Connection
Figure 16: RJ45 port pins configuration
Note : pin4 and pin5 are internally connected on PCB board, pin7 and pin8 are internally
connected board on PCB board.
©
2008 RuggedCom Inc. All rights reserved
21
Rev106
Advertisement
Table of Contents
