Idr Primary Data Interfaces; Idr Engineering Service Channel - Comtech EF Data CDM-600 Installation And Operation Manual

CDM-600 Satellite Modem
Open Network Operations
9.4.1

IDR Primary Data Interfaces

When configured for IDR operation, the board performs these functions:
Multiplexes in compliance with the standard IESS-308 96 kbps ESC overhead onto the
data and provides both the data and rate exchanged clock to the modulator portion of the
base modem.
Performs the corresponding demultiplexing of Rx satellite data received from the
demodulator portion of the modem. Resulting G.703 data is optionally encoded (AMI,
B8ZS, or HDB3) before being output.
9.4.2

IDR Engineering Service Channel

Bi-directional processing of the components of the ESC channel, including the ADPCM
audio channels, 8 kbps data channel, and fault indications specified by IESS-403 and
IESS-308.
Option of using the ADPCM portion of the satellite overhead for a single 64 kbps ESC
data channel in addition to (and with the same format as) the 8 kbps data channel.
When using G.703 format for the primary IDR data path, the P3B primary data interface
(25-pin) is used for the 8kbps overhead channel. If EIA-422 or V.35 is used, P3B
becomes the primary interface and the 8kbps channel is unavailable.
•
Receives and performs clock and data recovery on incoming G.703 T1 and
E1 pseudo-ternary data.
•
Clock dejitter is performed per G.823 and G.824, and any data decoding
(AMI, B8Z5, or HDB3) required per G.703 is also accomplished.
IDR Framing
9–5
Revision 7
MN/CDM600.IOM