Table of Contents
Advertisement
Installation
To install the Intelix DIGI-HDMI-4X2 matrix switcher, please perform the
following steps.
1. If mounting in a 19" audio/video rack, affix the 19" rack ears to the DIGI-
HDMI-4X2. The DIGI-HDMI-4X2 requires 1 rack unit of spacing.
Ventilation when Rack Mounting
At least 2 inches of free air space is required on both sides of
the DIGI-HDMI-4X2 for proper side ventilation.
Ensure there are no closeable doors on the rack that might seal
the DIGI-HDMI-4X2 from a steady supply of cool air.
Avoid mounting the DIGI-HDMI-4X2 near a power amplifier
or any other source of significant heat.
It is recommended that you leave an empty rack space above
and below the DIGI-HDMI-4X2 for additional cooling.
2. Power-off the source and destination audio and video devices.
Note: All connecting audio-visual equipment must be powered off.
3. Connect the input sources to the DIGI-HDMI-4X2 using high-quality
HDMI or DVI and digital audio cables.
4. Connect the output destinations to the DIGI-HDMI-4X2 using high-quality
HDMI cables.
5. For long distance destinations, connect two runs of twisted pair cable per
run to the DIGI-HDMI-4X2 (twisted pair receivers sold separately).
www.intelix.com
Intelix DIGI-HDMI-4X2 Installation Manual
5
Advertisement
Table of Contents
