Ir Remote Control - Intelix DIGI-HDMI-4X2 Installation Manual

Intelix DIGI-HDMI-4X2 Installation Manual
8

IR Remote Control

The DIGI-HDMI-4X2 supports remote control through a front panel IR sensor
and a rear panel 1/8" (3.5 mm) input jack.
1. If controlling the DIGI-HDMI-4X2 through the 1/8" (3.5 mm) input jack on
the rear panel, connect the IR cable directly to the matrix.
Note: Operation of the rear panel IR input will disable the front
panel IR sensor.
2. If controlling the DIGI-HDMI-4X2 through the IR sensor on the front
panel, place an IR emitter directly over the front panel sensor.
IR Emitter Mounting Tips
Surrounding electrical equipment may be producing high
levels of IR noise. Plasma TVs and compact fluorescent lights
are known polluters. Shield the outside of the emitter and the
hardware's IR window with electrical tape.
Verify the emitter is directly on the hardware's IR window
and directly over the IR sensor. Operation may be intermittent
if the emitter is too far away from the sensor.
Clean the DIGI-HDMI-4X2 IR sensor window with an
alcohol-based cleaner before applying the emitter to guarantee
adhesion.
Should the emitter not adhere to the DIGI-HDMI-4X2 sensor
window, apply a small drop of glue to the adhesion pad on the
emitter and re-apply.
www.intelix.com