Intelix DIGI-HDMI-4X2 Installation Manual page 17

IR Twisted Pair Pass-Through
When used with compatible Intelix receivers (DIGI-HDMI-IR-R), the DIGI-
HDMI-4X2 supports two pass-through IR channels which distribute remote IR
commands from in-room controllers, up to 150 feet over twisted pair cable, and
out of the matrix.
1. Determine which devices you wish to control via the IR pass-through
outputs.
Note: By default, IR transmit output one corresponds to HDMI input
one, IR transmit output two corresponds to HDMI input two, IR
transmit output three corresponds to HDMI input three, and IR
transmit output four corresponds to HDMI input four. Therefore, the
IR output port will control the source connected to the HDMI input.
2. Connect an IR cable to the desired IR transmit output port.
3. Repeat for up to four devices.
Note: Optionally, IR commands for the matrix may be transmitted
from a remote receive balun. For successful operation, the output of
the IR transmit output port must be routed to the 1/8" (3.5 mm) IR
rear panel connector or the front panel IR sensor.
www.intelix.com
Intelix DIGI-HDMI-4X2 Installation Manual
17