Intelix DIGI-HDMI-4X2 Installation Manual page 13

Ethernet Remote Control
The DIGI-HDMI-4X2 supports remote control through a rear panel Ethernet
control port. The matrix accepts control messages when integrated to a local
area network (LAN).
1. If controlling the DIGI-HDMI-4X2 through the Ethernet control port on the
rear panel, connect an Ethernet cable directly to the matrix.
Note: The DIGI-HDMI-4X2 will automatically be assigned an IP
address when connected to a DHCP-enabled network.
2. Connect the opposite end of the Ethernet cable to a LAN port. Within 10
seconds of connecting the DIGI-HDMI-4X2 to the LAN, the yellow LED
on the matrix's Ethernet port will stop blinking and the green LED will
blink intermittently.
Connection Troubleshooting: If the matrix does not respond with
a green LED, please follow the steps below:
- Verify the LAN has DHCP support.
- Verify the LAN port is active.
- The LAN port on the DIGI-HDMI-4X2 requires the use of
an Ethernet crossover cable if the hub or switch that you
are connecting to does not support Automatic MDI/MDI-X.
- If you continue to have issues getting the matrix to connect
to the LAN, verify LAN connectivity using a PC. If you
can not get a PC to connect, contact a network
administrator for assistance
Controlling the Matrix over a LAN
Intelix provides a diagnostic software utility, NetCtl, to
determine the IP address of the DIGI-HDMI-4X2 and to
test Ethernet control functions. Please visit Intelix's online
technical library to download the latest version of the
software:
http://www.intelix.com/tech_library/software.htm.
1. Download and install NetCtl on your computer.
2. Launch the utility. Two buttons appear.
www.intelix.com
Intelix DIGI-HDMI-4X2 Installation Manual
13