Peak load cut off
When activating the peak load cut off the
heat is turned off and the program is
stopped. The display shows:
Program stop by peak load function
The program continues.
When the peak load function ends the
program will continue automatically.
A serial interface is located at the rear of the
washer to connect the machine to a PC
PC-Operation: Program changes can be
made via a PC, or a new program can be
It is possible to print out whole programs or
parts of programs.
This requires a special Editor Program which
is available from the Miele Professional
If the machine is equipped with a load
module, the load weight will be displayed, in
0.5 lb increments, while loading the laundry.
The maximum laundry weight is displayed
next to the selected program.
^ Reset with the -> I <- "zero setting" if the
weight display does not show "00.0" when
the drum is empty.
If there was still laundry in the drum when
the weight display was reset, the display
^ Reset again with the -> I <- button.
If the machine is overloaded (wet laundry)
the machine calculates after the programs
start with the nominal value. This value is
saved in the operating data module.
At the end of a program, with the drum
stationary, the residual moisture of the
laundry is displayed.
Door can be opened..
See "Use - Adjust the program" for more
Residual moisture 60 %
-> I <-
- - .-
-> I <-