Peak Load Cutoff; Pc Connection; Load Module - Miele PW 6321 Operating And Installation Instructions

Peak load cutoff

When activating the peak load cutoff the
heat is turned off and the program is
stopped. The display shows:
1 Hot Wash
Program stop - Peak load function
Program will continue.
ü
i
When the peak load function ends the
program will continue automatically.

PC Connection

A serial interface is located at the rear of the
washer to connect the machine to a PC
(Personal Computer).
PC-Operation: Program changes can be
made via a PC, or a new program can be
downloaded.
Printer-Operation:
It is possible to print out whole programs or
parts of programs.
This requires a special Editor Program which
is available from the Miele Professional
Department.

Load module

If the machine is equipped with a load
module, the load weight will be displayed, in
0.5 lb increments, while loading the laundry.
The maximum laundry weight is displayed
next to the selected program.
^ Reset with the -> I <- "zero - setting" if the
weight display does not show "00.0" when
f
the drum is empty.
1 Hot Wash
140 °F Main wash
Rinse
+i
If there was still laundry in the drum when
the weight display was reset, the display
shows:
1 Hot Wash
140 °F Main wash
Rinse
+i
^ Reset again with the -> I <- button.
If the machine is overloaded (wet laundry)
the machine calculates after the programs
start with the nominal value. This value is
saved in the operating data module.
At the end of a program, with the drum
stationary, the residual moisture of the
laundry is displayed.
1 Hot Wash
Program end
Door can be opened.
See "Use - Adjust the program" for more
information.
Optional modules
m k m
m k m
Residual moisture 60 %
FC
m
00.0 / 56 lb
e
A
-> I <-
- -.- / 56 lb
e
A
-> I <-
A
27