Setup - Connections; Ip Range - Bosch Divar 700 Series Installation And Operation Manual

Divar 700 Series
6.9.2

Setup - Connections

Figure 6.12 Configuration menu - Network - Setup - Connections
Units with a secondary Ethernet connector show the fields for configuring this port as well as
the primary port.
–
–
–
–
–
6.9.3

IP Range

–
–
Only workstations (with the Control Center or Configuration Tool) that have an IP address in
one of the specified ranges can gain access to the unit.
Bosch Security Systems
Enable DHCP to have IP address, subnet mask, and default gateway assigned
automatically by the network DHCP server. The actual values are displayed.
If DHCP is disabled, fill in the IP address, the Subnet mask, and the Default gateway
address for the recorder.
The MAC address is read only; it shows the MAC address of the Ethernet adapter.
Connection shows the status of the physical network connection.
Restrict the network bandwidth by entering a Mbps value between 0.1 and 100 for the
Bandwidth limit.
Eight IP ranges can be entered to allow access.
Enter the same begin and end address to specify a single IP address. Enter different
begin and end addresses to specify an IP address range.
Installation and Operation manual
Advanced configuration menu | en
F.01U.140.955 | v3.0 | 2009.11
73