Normal; Contact; Motion - Bosch Divar 700 Series Installation And Operation Manual

Divar 700 Series
6.4.1

Normal

Set values for each of the following fields:
–
–
–
–
–
–
–
Note:
For the most efficient image compression, avoid camera noise by making sure that the camera
has been set up correctly and enough lighting is available. In addition, ensure that the camera
is mounted so that it does not shake due to wind or other influences.
6.4.2

Contact

The fields have the same parameters as those under the Normal tab. Additional fields are
present for contact recording.
–
–
6.4.3

Motion

The fields have the same parameters as those under the Normal tab. Additional fields are
present for motion recording.
–
–
Note:
If Event only recording has been selected under the Normal tab, then the pre-event time also
applies for contact and motion recordings.
Bosch Security Systems
Normal recording mode:
– Continuous - set to record continuously
– Event only - set to record events only
– No Recording - set to disable recording
Pre-Event Time:
– set between 1 and 120 seconds (only applicable when recording Event only)
The recoding for the event starts this amount of time before the event occcurs.
Resolution:
– set the video resolution to 4CIF (704 x 576/480 PAL/NTSC), 2CIF (704 x 288/240
PAL/NTSC), or CIF (352 x 288/240 PAL/NTSC).
Quality:
– set the video quality setting to High, Medium or Standard.
Frame rate:
– set the video frame rate to 25/30, 12.5/15, 6.25/7.5, 3.125/3.75 or 1/1 ips (images
per second in PAL/NTSC).
Record audio:
– check to enable audio recording.
Audio quality:
– set the audio quality to High, Medium or Standard.
Contact recording:
– Fixed duration - activates recording for the set duration from the start of the event.
– Follows + Post - activates recording as long as the event is active and continues
after the event becomes inactive for the time set in the duration field.
– Follows - activates the recording only as long as the event is active.
– No recording
Set the duration time in minutes and seconds.
Motion recording:
– Fixed duration - activates recording for the set duration from the start of the event.
– No recording
Set the duration time in minutes and seconds.
Installation and Operation manual
Advanced configuration menu | en
F.01U.140.955 | v3.0 | 2009.11
65