Contact; Motion; Video Loss; Copy - Bosch Divar 700 Series Installation And Operation Manual

Divar 700 Series
6.8.2

Contact

The event behavior can be configured for each of the 16 input contacts in turn.
–
–
Actions
Click Edit... to set up Recording, Monitor and PTZ actions that should be carried out when
this contact is active.
–
–
–
Any actions that have been configured are listed.
6.8.3

Motion

The event behavior for motion detection can be configured for each video channel in turn.
–
–
Actions
Click Edit... to set up Recording, Monitor and PTZ actions that should be carried out when
motion is detected.
–
–
–
Any actions that have been configured are listed.
6.8.4

Video loss

The event behavior for video loss signals can be configured for each video channel in turn.
–
6.8.5

Copy

The copy event settings function makes it easy to set up a large number of events for all
profiles and all cameras. The copy function copies content from within a single profile to other
profiles. The camera inputs and the action types within each of these profiles can be selected.
To copy event settings:
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems
Check the Enabled box if the input contact should activate an event.
Check the Alarm box if the input contact should activate an alarm.
Recording: highlight the video channels to be recorded at contact recording settings
when this input contact is active (highlight the un-numbered box to select all). A list of
the selected channels and their recording properties is shown.
Monitor: highlight the video channels to be displayed on monitors A and B when this
input contact is active (highlight the un-numbered box to select all).
PTZ: enter a pre-position number from 1-1023 for each of the PTZ cameras that should
be moved (PTZ must be enabled for corresponding camera input).
Check the Enabled box if motion detection should activate an event.
Check the Alarm box if motion detection should activate an alarm.
Recording: highlight the video channels to be recorded at motion recording settings
when motion is detected (highlight the un-numbered box to select all). A list of the
selected channels and their recording properties is shown.
Monitor: highlight the video channels to be displayed on monitors A and B when motion
is detected (highlight the un-numbered box to select all).
PTZ: enter a pre-position number from 1-1023 for each of the PTZ cameras that should
be moved (PTZ must be enabled for corresponding camera input).
Check the Enabled box for each video channel if video loss should activate an event.
Check the Copy multiple cameras box to copy several camera inputs within the From
profile.
Select the profile number to copy from.
Highlight the profiles to copy to (highlight the un-numbered box to select all).
Select the camera input(s) to be copied from, for the profile to be copied.
Select the camera inputs to be copied to (hightlight the un-numbered box to select all).
Check only those actions (General, Contact, Motion or Video loss) to be copied.
Click Copy.
Installation and Operation manual
Advanced configuration menu | en
F.01U.140.955 | v3.0 | 2009.11
71