Installation; Make Connections - Bosch DIVAR 2000 Installation Manual

8 en | Safety
5

Installation

Notice!
Use proper surge suppression on cables that are routed outdoors, or close to large inductive
loads or electrical mains supply cables.
Caution!
! Installation should only be performed by qualified service personnel in accordance with the
National Electrical Code (NEC 800 CEC Section 60) or applicable local codes.
To get the unit operational, perform the following quick install steps:
1.
2.
3.
4.
After completing this initial setup, the system is ready to run and will show a live view of the
camera image(s). If required, you can alter the settings later using the menus and/or factory
defaults, or you can run the Startup wizard again.
5.1

Make connections

Notice!
Use only PoE approved devices.
1.
2.
3.
Optional connections (depending on model)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Connect a Bosch Intuikey keyboard cable to the
11. Connect an eSATA storage device to the
2016.08 | v1.0 | AM18-Q0712
Make all required hardware connections – see Make Connections.
Power up the system – see Powering Up.
Log in – see Login.
Correctly configure your system software with the Startup wizard (this appears the first
time the unit is started) – see Startup Wizard.
Connect the cameras to the
– If using PoE connector, power is supplied to the camera via the Ethernet cable
compliant with the Power-over-Ethernet standard.
– Use an external switch to connect more cameras to a single RJ45
Connect monitor A to the
Connect the USB mouse to a USB port (back or front panel).
Connect a second dual monitor to the optional
Connect up to 4 audio signals to the
Connect 1 microphone to the
Connect 1 RCA (CINCH) output from
Connect up to 16 alarm inputs to the
blocks).
Connect up to 6 alarm outputs to the
blocks).
Connect a pan/tilt/zoom control unit to the
Connect to your network via the RJ45 ETHERNET connector
Pair Category 5e cable).
Connect extra video out cables to the
devices (only for DIVAR 5000 hybrid).
adaptor (only for DIVAR 5000).
or connectors.
output, or the
RCA (CINCH) inputs.
RCA (CINCH) input.
connector (via the supplied terminal
connector (only for DIVAR 5000).
Installation Manual
DIVAR 2000 / DIVAR 3000 / DIVAR
output.
connector.
to the monitor or an audio amplifier.
connector (via the supplied terminal
(only for hybrid models).
(use Shielded Twisted
ports if loop through is required to other
connector using the supplied
Bosch Security Systems
5000
port.