Table of Contents
Advertisement
DIVAR IP all-in-one 7000 2U
8
System setup
The DIVAR IP all-in-one 7000 systems are based on the operating system Microsoft Windows
Server IoT 2019 for Storage Standard. The operating system provides an user interface for
initial server configuration, unified storage appliance management, simplified setup and
storage management, and support for Microsoft iSCSI Software Target.
It is specially tuned to provide optimal performance for network-attached storage. The
Microsoft Windows Server IoT 2019 for Storage Standard operating system provides
significant enhancements in storage management scenarios, as well as integration of storage
appliance management components and functionality.
Notice!
This chapter is valid for DIVAR IP all-in-one 7000 models that come with pre-installed hard
i
drives.
The operating system of empty units loaded with third party hard drives will start normally,
but the added hard drives must be configured with the RAID utility prior to initial software
setup.
Refer to
–
8.1
Default settings
DIVAR IP systems are shipped with a pre-installed Configuration Wizard from factory.
All DIVAR IP systems are preconfigured with a default IP address and with default iSCSI
settings:
–
–
Default user settings for administrator account
–
–
8.2
Prerequisites
Observe the following:
–
–
8.3
Operating modes
Operating modes
The DIVAR IP all-in-one systems can operate in three different modes:
–
–
–
Bosch Security Systems B.V.
Configuring hard drives using the RAID setup, page 28
IP Address: automatically assigned by DHCP (fallback IP address: 192.168.0.200).
Subnet mask: automatically assigned by DHCP (fallback subnet mask: 255.255.255.0).
User: BVRAdmin
Password: to be set at first logon.
DIVAR IP needs to have an active network link during installation. Make sure that the
network switch you are connecting to is powered on.
The default IP address must not be occupied by any other device in the network. Make
sure that the default IP addresses of existing DIVAR IP systems in the network are
changed before adding another DIVAR IP.
Full video recording and management system, utilizing the BVMS and VRM core
components and services: This mode allows for advanced video management features
such as event and alarm handling.
Pure video recording system, utilizing the VRM core components and services.
iSCSI storage expansion for a BVMS or VRM system, which runs on a different hardware.
Installation manual
System setup | en
27
2020.11 | V1.1 | DOC
Advertisement
Table of Contents
