Viewing Pictures; Monitor A; Monitor B (Hybrid Version Only); Viewing - Bosch Divar 700 Series Installation And Operation Manual

40 en | Operating instructions
5.3

Viewing pictures

The hybrid version has two monitor outputs, A and B. The way in which these monitors display
pictures depends on how the system is configured. When an alarm or motion input is
detected, the camera picture with the Alarm/Motion indicator can be displayed on monitor A,
B, or both. When multiple alarms or motion occur, camera pictures are combined in a
multiscreen window on monitor A, B, or both.
5.3.1

Monitor A

Monitor A is the main monitor. It shows full-screen, quad, or multiscreen live or playback
pictures of both analog and IP cameras. Status messages, alarms, motion, and video loss
warnings are also displayed on this monitor. When the menu system is activated it is
displayed on this monitor.
5.3.2

Monitor B (hybrid version only)

Monitor B displays full-screen, quad, or multiscreen live pictures of analog cameras.
Selecting a monitor to control
To control the display on monitor A:
1.
2.
To control the display on monitor B:
1.
2.
5.3.3

Viewing

The drawing shows all possible views for monitor A and B. Some multiscreen views may have
been disabled during set up. The Divar model and the number of connected cameras also
influence the available multiscreen views.
Figure 5.3 Supports single, quad, 3x3, and 4x4 screen viewing
The multiscreen modes can have different multiscreens that can be shown in sequence to
display all camera pictures.
F.01U.140.955 | v3.0 | 2009.11
Check that the light on the front panel is lit.
If is not lit, press the monitor
Check that the light on the front panel is lit.
If is not lit, press the monitor
Single
1
Quad
1 2
3
4
Installation and Operation manual
key.
key
4x4
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
3x3
1 2 3
4 5 6
7 8 9
Divar 700 Series
Bosch Security Systems