Table of Contents
Advertisement
2
Attaching Fully Adjustable
Flagangles to vertical Track
Tools Needed:
NOTE: If quick install flagangles were
installed in step 1, skip this step and
None
continue with step 3. If not, complete
this step.
If you have quick install vertical track,
hand tighten the flagangle to the
vertical track using (1) stud plate and
(2) 1/4" - 20 flange hex nuts. Repeat for
other side.
secure the flange nuts after flagangle
spacing is complete (step 15).
If you have fully adjustable vertical
track, hand tighten the flagangle to the
vertical track using (2) 1/4"- 20 x 9/16"
track bolts and (2) 1/4"- 20 flange hex
nuts. Repeat for other side.
secure the flange nuts after flagangle
spacing is complete (step 15).
3
Tools Needed:
Position the horizontal angle as shown.
Place tabs of horizontal angle in the key
hammer
slot of horizontal track. using a hammer,
tap the horizontal angle towards the
curved end of the track until the hole in
track and angle are aligned. set tracks
aside.
NOTE: for larger doors, a full length
horizontal angle may be spot welded
to the horizontal track. If the horizontal
angle is not welded, the horizontal angle
must be installed as shown.
8
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
horizontal Angles
fully aDjusTablE
flaGaNGlE
1/4"- 20
flaNGE hEx
NuTs
sTuD
quICk INsTall
PlaTE
VERTICal TRaCk
quICk INsTall TRaCk
Tabs
hOlE
hORIzONTal TRaCk
hORIzONTal aNGlE
fully aDjusTablE
flaGaNGlE
1/4"- 20
flaNGE hEx
NuTs
fully aDjusTablE
VERTICal TRaCk
(2) 1/4"- 20 x 9/16"
TRaCk bOlTs
fully aDjusTablE TRaCk
hORIzONTal
aNGlE
kEy slOT
hOlE
hORIzONTal
TRaCk
hORIzONTal
hORIzONTal
TRaCk
aNGlE
hORIzONTal
TRaCk
Tabs
Advertisement
Table of Contents
