Table of Contents
Advertisement
Winding Springs Continued...
wheel for winding or place a mark on
Tools Needed:
the winding shaft and end bracket.
Place the ratchet with 5/8" socket onto
the left hand winding shaft end. To wind
the spring, rotate the winding shaft
clockwise, while watching the black
tooth on the ratchet wheel or the mark
on the winding shaft.
Rotate the winding shaft to the required
number of turns for your door. Then
return to the right hand side and wind
the right hand spring to the required
number of turns. Place pawl knob in
lower position on both sides.
IMPORTANT: Mark number of spring
turns on TorqueMaster
bracket warning tag.
NOTE: since total turns to balance door
can deviate from sPRING TuRN ChaRT
values by ± 1/2 turn, adjustments to the
recommended number of turns may be
required afTER rear hangers assembly
is completed.
IMPORTANT!
TO PREVENT IT fROM RIsING
uNExPECTEDly IN ThE EVENT ThE
sPRING Was OVERWOuND aND
CauTIOusly REMOVE VICE ClaMPs
fROM VERTICal TRaCks.
27
Drum Wrap Installation
Tools Needed:
To install drum wraps, position the left
hand drum wrap over the left hand
step ladder
drum, align with counterbalance cable;
slide groove in drum wrap towards the
left until tabs snap over drum between
drum and ratchet gear. Repeat for right
hand side.
26
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Plus end
®
hOlD ThE DOOR DOWN
bACk OF TORqUEMASTER
PlUS END bRACkET WARNING TAG
®
Spring Turns
Door Height
Spring Turns
(6' - 0")
(6' - 3")
(6' - 5")
(6' - 6")
(6' - 8")
(6' - 9")
(7' - 0")
(7' - 3")
(7' - 6")
(7' - 9")
(8' - 0")
Number of Installed Spring Turns
DRuM WRaP
(lEfT haND)
DRuM
(lEfT haND)
GROOVE
IN DRuM
COuNTERbalaNCE
CablE
14
14 - 1/2
15
15
15 - 1/2
15 - 1/2
16
16 - 1/2
17
17 - 1/2
18
lOCaTION fOR
MaRkING NuMbER
Of INsTallED
sPRING TuRNs
Tabs
Advertisement
Table of Contents
