Table of Contents
Advertisement
17
Attaching Adjustable Flagangles
to horizontal Tracks
NOTE: If quick install flagangles were
Tools Needed:
installed in step 16, skip this step and
7/16" socket
continue with step 18. If not, complete
9/16" socket
this step.
Ratchet Wrench
To install horizontal track, place the
9/16" Wrench
curved end over the top roller. align
level
the bottom of the horizontal track with
the vertical track. If you have quick
step ladder
install horizontal track, hand tighten the
horizontal track to the flagangle with
a studplate and (2) 1/4"-20 flange
hex nuts. If you have fully adjustable
horizontal track, hand tighten the
horizontal track to the flagangle with
(2) 1/4" - 20 x 9/16" track bolts and (2)
1/4"-20 flange hex nuts.
WARNING
DO NOT RaIsE DOOR uNTIl
hORIzONTal TRaCks aRE
sE CuRED aT REaR, as OuTlINED
IN sTEP 28, OR DOOR COulD
fall fROM OVERhEaD POsI-
TION CausING sEVERE OR faTal
INjuRy.
level the horizontal track assembly and
bolt the horizontal angle to the slot in
the flagangle using (1) 3/8"-16 x 3/4"
truss head bolt and (1) 3/8"-16 hex nut.
Repeat for other side.
Remove the nail that was temporarily
holding the top section in place, installed
in step 15.
IMPORTANT: faIluRE TO REMOVE NaIl
bEfORE aTTEMPTING TO RaIsE DOOR
COulD CausE PERMaNENT DaMaGE TO
TOP sECTION.
NOTE: If an
installed, position horizontal tracks
slightly above level.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
idrive
opener will be
®
quICk INsTall
hORIzONTal TRaCk
flaGaNGlE
sTuDPlaTE
1/4"-20 flaNGE
hEx NuTs
quICk INsTall TRaCk
3/8" - 16 x 3/4"
TRuss hEaD bOlT
fully aDjusTablE
hORIzONTal TRaCk
flaGaNGlE
1/4"-20 flaNGE
hEx NuTs
1/4"-20 x 9/16"
TRaCk bOlTs
fully aDjusTablE TRaCk
3/8" - 16 hEx NuT
hORIzONTal aNGlE
hORIzONTal TRaCk
19
Advertisement
Table of Contents
