Table of Contents
Advertisement
16
Attaching quick Install Flagangles
NOTE: If you have fully adjustable
Tools Needed:
flagangles, skip this step and complete
9/16" socket
step 17.
Ratchet Wrench
To install horizontal track, place the
9/16" Wrench
curved end over the top roller. align
level
key slot of the horizontal track with the
quick install tab of the flagangle. Push
step ladder
curved portion of horizontal track down
to lock in place.
DO NOT RaIsE DOOR uNTIl
hORIzONTal TRaCks aRE
sE CuRED aT REaR, as OuTlINED
IN sTEP 28, OR DOOR COulD
fall fROM OVERhEaD POsI-
TION CausING sEVERE OR faTal
INjuRy.
level the horizontal track assembly and
bolt the horizontal angle to the slot in
the flagangle using (1) 3/8" - 16 x 3/4"
truss head bolt and (1) 3/8" - 16 hex
nut. Repeat for other side. Remove the
nail that was temporarily holding the
top section in place, installed in step
15.
IMPORTANT: faIluRE TO REMOVE NaIl
bEfORE aTTEMPTING TO RaIsE DOOR
COulD CausE PERMaNENT DaMaGE
TO TOP sECTION.
NOTE: If an
installed, position horizontal tracks
slightly above level.
NOTE: after completing this step,
continue with step 18.
18
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
to horizontal Tracks
WARNING
idrive
opener will be
®
hORIzONTal
TRaCk
quICk
INsTall
Tab
VERTICal
TRaCk
hORIzONTal
quICk
TRaCk
INsTall
kEy slOT
VERTICal
TRaCk
3/8" - 16 x 3/4"
TRuss hEaD bOlT
kEy
slOT
Tab
3/8" - 16 hEx NuT
hORIzONTal aNGlE
hORIzONTal TRaCk
Advertisement
Table of Contents
