Table of Contents
Advertisement
12
Stacking Sections
NOTE: for door section identification see
Tools Needed:
page 4.
Power Drill
NOTE: Make sure hinges are flipped down,
when stacking another section on top.
7/16" socket
NOTE: larger doors will use long shaft
Driver
rollers with double wide end hinges
Place rollers in hinge tubes of the second
section (lock section). With assistance, lift
second section and guide rollers into the
vertical tracks. keep patterns on front of
sections aligned, and fasten center hinges
first and end hinges last with 1/4"-14 x
5/8" self tapping screws. Repeat for other
section(s) except top section.
IMPORTANT: Push & hOlD ThE hINGE
lEaf aGaINsT sECTION WhIlE sECuRING
WITh 1/4"-14 x 5/8" sElf TaPPING
sCREWs. END hINGEs haVE (2) sCREWs
aND INTERMEDIaTE hINGEs haVE (3)
sCREWs; DOublE END hINGEs haVE (5)
sCREWs.
NOTE: lock(s) are required if door is not
installed with opener. Install lock at this
time (sold separately) see instructions in
OPTIONal INsTallaTION on page 32.
13
Top Roller Slides
Tools Needed:
To install the top roller slides, align
the slots in the top roller slide with the
Power Drill
second set of holes on the bottom of the
7/16" socket
u-bar.
Driver
step ladder
loosely, fasten using (2) 1/4" - 14 x 5/8"
self tapping screws. The bracket will be
tightened and adjusted in step 18. Insert
rollers into top roller slide. Repeat for
left side.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
(2) 1/4"-14 x 5/8"
sElf TaPPING sCREWs
END hINGEs (lEfT haND shOWN, RIGhT
hINGE syMMETRICally OPPOsITE)
TOP RIGhT sIDE
ROllER
(2) 1/4"- 14 x 5/8"
sElf TaPPING
sCREWs
(5) 1/4"-14 x 5/8" sElf
TaPPING sCREWs
DOublE END hINGEs (lEfT haND shOWN,
RIGhT hINGE syMMETRICally OPPOsITE)
(3) 1/4"-14 x 5/8" sElf
TaPPING sCREWs
INTERMEDIaTE hINGEs
3RD
2ND
1sT
TOP ROllER slIDE
15
Advertisement
Table of Contents
