Table of Contents
Advertisement
24
Tools Needed:
Place vice clamps onto both vertical
tracks just above the third roller. This is
Vice Clamps
to prevent the garage door from raising
while winding the counterbalance
springs.
faIluRE TO PlaCE VICE
ClaMPs ONTO VERTICal
TRaCks CaN allOW DOOR TO
RaIsE aND CausE sEVERE OR
faTal INjuRy
25
Tools Needed:
Check to ensure the cable is aligned
and seated in the first and second
Vice Grips
groove of the cable drum. snug the set
screw, and then tighten an additional
Pliers/Wire
Cutters
1-1/2 turns.
IMPORTANT: ENsuRE ThE CablE Is
flat Tip
alIGNED aND sEaTED IN ThE fIRsT
screwdriver
GROOVE Of ThE CablE DRuM PRIOR TO
WINDING sPRINGs.
step ladder
Measure approximately 6" of cable and
cut off excess cable. Insert end of cable
in hole of cable drum.
NOTE: Illustrations show the right
TorqueMaster
TorqueMaster
symmetrically opposite.
24
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Securing Door
for Spring Winding
WARNING
.
Cable Adjustment
Plus drum, left
®
Plus drum is
®
1-1/2 WRaP
CaM PEak
6"
sET sCREW
PlaCE VICE
ClaMPs abOVE
3RD ROllER
VICE ClaMPs
TRaCk
aTTaChED TO
TRaCk
CablE DRuM hOlE
fIRsT aND
sECOND
GROOVE
RIGhT haND
DRuM
Advertisement
Table of Contents
