Table of Contents
Advertisement
6
Pull handle Installation
Tools Needed:
On single doors, locate and mark the
horizontal and vertical center on the
Tape Measure
bottom rail of the bottom section.
Pencil
Center the pull handle using the vertical
Power Drill
and horizontal lines as reference on the
1/16" Drill bit
bottom section rail as shown. using the
pull handle as a template, mark the two
holes in the pull handle on the horizontal
line of the bottom section rail. Drill a
1/16" pilot hole, then fasten pull handles
using (2) #10 x 5/8" pan head self
tapping screws.
NOTE: Reference illustrations for pull
handle positions on single and double
car garage doors. If your door came with
two pull handles they must be installed
as shown in the bottom illustration.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
bOTTOM
sECTION
lOCaTE ThE CENTER
bOTTOM
sECTION
Pull haNDlE
Pull haNDlE PlaCEMENT REfERENCE ON sINGlE WIDE DOORs
Pull haNDlE PlaCEMENT REfERENCE ON DOublE WIDE DOORs
8" Max.
bOTTOM Of ThE DOOR
(2) #10 x 5/8"
PaN hEaD
sElf TaPPING
sCREWs
11
Advertisement
Table of Contents
