Table of Contents
Advertisement
�
TorqueMaster® Plus Reset
Instructions Continued...
bAlANCING DOOR:
Tools Needed:
lift the door and check its balance. adjust
springs, if door lifts by itself (hard to pull
down) or if door is difficult to lift (easy to
pull down). anytime spring adjustments
are made, ratchet pawl knob must be in
the upper position (see illustration). an
unbalanced door can cause idrive
Torquemaster
IMPORTANT! TO aDjusT sPRINGs, ONly
aDD OR REMOVE a MaxIMuM Of 3/10 Of
a TuRN (ThREE TEETh ON ThE RaTChET
WhEEl) aT a TIME. bOTh sIDEs NEED TO
bE aDjusTED Equally ON DOublE
sPRING DOORs.
Close the door and place vice clamps
onto both vertical tracks just above the
third roller. This is to prevent the garage
door from raising while adjusting the
counterbalance spring(s).
WARNING
PRIOR TO WINDING OR MakING
aDjusTMENTs TO ThE sPRINGs,
ENsuRE yOu'RE WINDING IN ThE
PROPER DIRECTION as sTaTED IN
ThE INsTallaTION INsTRuCTIONs.
OThERWIsE, ThE sPRING fITTINGs May
RElEasE fROM sPRING If NOT WOuND
IN ThE PROPER DIRECTION aND COulD
REsulT IN sEVERE OR faTal INjuRy.
To Add Spring Tension: The ratchet
wheel is made of 10 teeth. To add spring
tension, ensure the ratchet wrench is set
so that it will tighten counter clockwise
on the right hand side, and clockwise on
the left hand side. Place the ratchet
wrench with 5/8" socket onto the winding
shaft, pull down to add 3/10 of a turn.
Watch as three teeth of the ratchet wheel
pass over the pawl, creating three
"clicks".
To Remove Spring Tension: To remove
spring tension, ensure the ratchet wrench
is set so that it will tighten counter
clockwise on the right hand side and
clockwise on the left hand side. Place the
ratchet wrench with 5/8" socket onto the
winding shaft. Pull down on the ratchet to
relieve pressure between the pawl and
the ratchet wheel. Push in on the pawl to
allow the three ratchet wheel teeth to
pass by the pawl, as you carefully allow
the ratchet wrench to be rotated upward
by the spring tension. Release the pawl to
allow it to engage with the ratchet wheel.
Remove the vice clamps from the vertical
tracks, re-check door balance and adjust
if necessary. When door is balanced and
adjusted properly, place the ratchet pawl
knobs in the active position (lower
position).
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
or
®
®
Plus operation problems.
lOWER POSITION
PaWl kNOb IN lOWER
POsITION
END bRaCkET
PaWl
3" ExTENsION
PlaCE VICE ClaMPs
abOVE 3RD ROllER ON
bOTh VERTICal TRaCk
VICE ClaMPs
TRaCk
aTTaChED TO
INNER RaIl
Of TRaCk
UPPER POSITION
PaWl kNOb IN uPPER
POsITION
RaTChET
5/8" sOCkET
31
Advertisement
Table of Contents
