Interface - Fujitsu MHU2100AT Product Manual

1.1.3 Interface

(1) Connection to ATA interface
The disk drive has built-in controllers compatible with the ATA interface.
(2) Data buffer
The disk drive use a 8MB data buffer to transfer data between the host and the
disk media.
In combination with the read-ahead cache system described in item (3) and the
write cache described in item (7), the buffer contributes to efficient I/O
processing.
(3) Read-ahead cache system
After the execution of a disk read command, the disk drive automatically reads the
subsequent data block and writes it to the data buffer (read ahead operation). This
cache system enables fast data access. The next disk read command would normally
cause another disk access. But, if the read ahead data corresponds to the data
requested by the next read command, the data in the buffer can be transferred instead.
(4) Master/slave
The disk drive can be connected to ATA interface as daisy chain configuration.
Drive 0 is a master device, drive 1 is a slave device.
(5) Error correction and retry by ECC
If a recoverable error occurs, the disk drive itself attempt error recovery. The
ECC has improved buffer error correction for correctable data errors.
(6) Self-diagnosis
The disk drive has a diagnostic function to check operation of the controller and
disk drive. Executing a diagnostic function of the smart command invokes self-
diagnosis.
(7) Write cache
When the disk drive receives a write command, the disk drive posts the command
completion at completion of transferring data to the data buffer completion of
writing to the disk media. This feature reduces the access time at writing.
C141-E202-01EN
1.1 Features
1-3